Home›Products›Ultrasonic Accessories

Ultrasonic testing accessories

Small components.
Signal-critical performance.

A focused range of couplants, corrosion-control additives, calibration blocks and ultrasonic probes for dependable manual and automated ultrasonic testing.

Manual UTWall thicknessImmersionCalibration
Ultrasonic probes and accessories from the NDT Technologies product range
Product family 01Ultrasonic Accessories
Temperature capabilityup to +290 °CHigh-temperature couplant
Calibration standardsEN ISO / DIN EN ISOReference blocks

Engineered around the ultrasonic signal path

Everything around the instrument matters.

Reliable ultrasonic testing depends on more than the flaw detector. Coupling quality, corrosion control, calibration references and probe selection directly influence repeatability and confidence in the result.

NDT Technologies supplies an accessory range for manual UT, wall-thickness measurement, immersion testing and application-specific probe configurations.

Couple

Stable acoustic transfer from probe to component.

Protect

Corrosion control for water-based UT circuits.

Calibrate

Reference standards for controlled UT setup.

Transmit

Probe families matched to geometry and frequency.

Product range

Build the right ultrasonic setup.

Select a category to review its role, operating characteristics and recommended use.

Echotrace ultrasonic couplant Manual UT

Couplants

Echotrace & high-temperature couplants

Water-based couplant supports clean, reliable manual ultrasonic coupling, while a silicone-oil high-temperature grade extends measurement capability for hot components.

Standard range0 to +80 °C
High-temp range−40 to +290 °C
  • Clean alternative to oil or grease for routine manual UT
  • Corrosion-inhibiting formulation
  • High-temperature option for hot surfaces
Ask about this product →

Selection logic

Choose around the test condition—not the catalogue page.

Start with the component, surface temperature, ultrasonic frequency, coupling method and required reference standard. NDT Technologies can then help match the accessory or probe to the inspection setup.

Discuss your UT setup →
  1. 01
    Define the component

    Material, geometry, surface condition and accessibility.

  2. 02
    Define the method

    Manual contact, thickness measurement, immersion or automated UT.

  3. 03
    Define the environment

    Temperature, corrosion-control needs and coupling circuit.

  4. 04
    Match the accessory

    Couplant, inhibitor, reference block and probe configuration.

Where the range fits

Ultrasonic accessories for real inspection workflows.

From routine wall-thickness checks to automated immersion systems, accessories are selected to support consistent signal quality and repeatable setup.

Manual flaw detection

Couplants and probes for welds, forgings and general component inspection.

Wall thickness

Low-viscosity coupling and transducers for thickness and corrosion measurement.

Immersion UT

Water additives help protect components, mechanics and coupling circuits.

Calibration & certification

Reference blocks support controlled setup against recognized standards.